Nordic NRF 52805 Features:

• 64 MHz Arm® Cortex-M4
• 192 KB Flash + 24 KB RAM
• Bluetooth Low Energy
  • – It has Bluetooth 5.2e
  • – High Range, 2 Mbps
  • – Channel selection algorithm
• 2.4GHz Proprietary Protocol Support
• Very low 2.4 GHz radio that supports multiple protocols
  • +4 dBm TX Power
  • 97 dBm RX Sensitivity
  • 7 mA TX (4 dBm)
  • 4.6 mA TX (0 dBm)
  • 4.6mA RX (1 Mbps)
  • Integrated balun with single-end output
• SPI, TWI UART
• 2-channel, 12-bit ADC
• Built-in DC/DC Regulator
• 0.3 uA power consumption when the system is off
• 1.1 When the uA system is turned on, 24 KB RAM is used and RTC is running
• Designed to fit to a 2-ply small PCB
  • 2.48×2.46 mm WLCSP case
  • Much cheaper than a 4-layer PCB.
  • It only needs 10 circuit elements to work. (including 2 crystal capacitors)
  • It has a reference drawing of 9.5×8.8 mm. It is possible to access all the pins in this drawing.

Nordic NRF 52805 yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

BU04 is a dual-antenna ultra-wideband (UWB) module designed by Shenzhen Anxinke Technology Co., Ltd. based on Decawave’s DW 3000 series chips . BU04 integrates DW3000+STM32F103 MCU and supports dual onboard antennas or dual IPEX external antennas. BU04 can be used in two-way ranging , TDOA or PDOA positioning systems, with a positioning accuracy of up to 10 cm and supports a data rate of up to 6.8 Mbps. It can be widely used in precise positioning, underground positioning in coal mines, hospital personnel positioning, warehouse positioning, various indoor positioning and other fields.

• Integrated STM32F103 MCU
• Positioning accuracy 10 cm
• Center frequency CH5 (6489.5MHz), CH9 (7987.2MHz)
• Supports supply voltage from 2.5 V to 3.6 V
• Support dual antenna channels
• Operating temperature -40℃~ 85℃
• Support onboard antenna, compatible with IPEX external antenna
• Using RTLS infrastructure to extend communication range
• Data rate supports 850 K bps, 6.8 Mbps
• Supports two-way ranging and T DOA and PDOA
  positioning solutions
• Provide precise positioning and data transmission
• Support SPI interface
• 20 configurable GPIOs
• Compliant with IEEE 802.15.4-2015 UWB standard
• Compliant with IEEE802.15.4z (BPRF mode)

Ai-Thinker RF Module BU04 yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

Nordic NRF 9160: It is a compact and low-power solution by Nordic, with LTE technology that allows advanced data processing and secure access, as well as easy-to-use for high-level communication in one device. Thanks to the Cortex – M33 processor with ARM architecture, which can run in coordination with communication integration, your applications can serve as a complete solution. You can create LTE Modem, RF Front End solution and power management system applications by using this integration only.

• Built-in RFFE (Radio Frequency Front End)
• Capable of operating in 700-2200 MHz LTE band range
• 23 dBm output power
• GPS
• eDRX and PSM power protection modes
• Range development modes
• SMS, IPv4/IPv6
• TCP/UDP, TLS/DTLS
• Single pin 50 Ω antenna output
• UICC interface
• 64 MHz Arm® Cortex®-M33 CPU
• Reliable Arm TrustZone® architecture
• Application protection with Arm CryptoCell 310
• 1 MB Flash + 256 KB RAM
• 4 x SPI/UART/TWI
• PDM, I2S, PWM, ADC
• Automatic security and clock management
• 32 GPIO

Nordic NRF 9160 yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

Nordic NRF 52805 Features:

• 64 MHz Arm® Cortex-M4
• 192 KB Flash + 24 KB RAM
• Bluetooth Low Energy
  • – It has Bluetooth 5.2e
  • – High Range, 2 Mbps
  • – Channel selection algorithm
• 2.4GHz Proprietary Protocol Support
• Very low 2.4 GHz radio that supports multiple protocols
  • +4 dBm TX Power
  • 97 dBm RX Sensitivity
  • 7 mA TX (4 dBm)
  • 4.6 mA TX (0 dBm)
  • 4.6mA RX (1 Mbps)
  • Integrated balun with single-end output
• SPI, TWI UART
• 2-channel, 12-bit ADC
• Built-in DC/DC Regulator
• 0.3 uA power consumption when the system is off
• 1.1 When the uA system is turned on, 24 KB RAM is used and RTC is running
• Designed to fit to a 2-ply small PCB
  • 2.48×2.46 mm WLCSP case
  • Much cheaper than a 4-layer PCB.
  • It only needs 10 circuit elements to work. (including 2 crystal capacitors)
  • It has a reference drawing of 9.5×8.8 mm. It is possible to access all the pins in this drawing.

Nordic NRF 52805 yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

Linx nSP250 nanoSplatch Antennas: Linx Technologies’ NanoSplatch nSP250 series antennas support SMD mounting for embedded Wi-Fi/WLAN and other 2.4 GHz or 5 GHz ISM or U-NII frequency band applications. Although the antennas have a small SMD shield, the grounded line technique is used to achieve outstanding performance. The NSP250 offers low interference with its multi-hemispherical radiation pattern, making it ideal for handsets and applications that are often subject to interference. The NSP250 is available in tape and reel packaging, and is designed to be placed directly onto a PCB for high-volume applications.

Linx nSP250 nanoSplatch Antennas 

• Ultra compact case (9.6mm x 8.4mm x 1.1mm)
• Excellent performance with very small size in horizontal plane (40 mm x 20 mm)
• Resistant to proximity interferences
• Multi-directional radiation pattern
• SMD mounting directly to the PCB
• Suitable for mass production board placement and manual assembly
• High gain (2.7 dBi at 2.4GHz, 3.7 dBi at 5.8GHz)
• High efficiency (66% at 2.4GHz, 69% at 5.8GHz)

Applications

• Single and dual band WIFI/WLAN/802.11
• Bluetooth and ZigBee
• Smart home network
• Detection and remote monitoring
• Handheld devices
• Internet of Things (IoT) Devices
• U-NII and ISM applications

Linx nSP250 nanoSplatch Antennas yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

HopeRF RFM95W LoRa transceivers are LoRaTM modules that provide ultra-long range propagation spectrum communication and high interference immunity, while also minimizing current consumption. Using HopeRF’s patented LoRaTM modulation technique, the RFM95W achieves a sensitivity of over -148dBm with low-cost crystal and materials. Together with the integrated +20 dBm power amplifier, it offers high precision and low connection cost, which makes the RFM95W LoRa module optimal for any application that requires range or robustness.

HopeRF RFM95W LoRa yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

Cavli C1RS LTE Advantages

• Built-in eSIM (Remote Programmable SIM)
• Access to local and global mobile data tariffs via Cavli Hubble
• Direct and very easy mobile subscription, activation and paying with Cavli Hubble
• Smart and automatic transition to local mobile subscription with eSIM
• Easy firmware installation/update with OTA/Over-the-air
• Ultra-Small case (15.8*17.7mm)

Data and Connection type

NB-IoT: 27.2 Kbps (UL), 62.5 Kbps (DL)

Technical Specifications

RF Bands LTE CAT NB: 3/5/8/20/26/28

• Standard: 3GPP Release 13
• MQTT/CoAP/LwM2M – YES, TLS 1.2 Supported
• TCP/IP/HTTP/HTTPS/FTP – YES
• Modes: In-Band, Guard Band
• 2uA Sleep Mode Power Consumption
• High Carrier Class Network Security
• 15.817.72.2mm, LCC Case

Cavli C1RS LTE yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

• Optional Built-in eSIM (Remote Programmable SIM)
• Access to local and global mobile data tariffs via Cavli Hubble
• Direct and very easy mobile subscription, activation and paying with Cavli Hubble
• Smart and automatic transition to local mobile subscription with eSIM
• Easy firmware installation/update with OTA/Over-the-air

• LTE-CAT 4: 50 Mbps (UL), 150 Mbps (DL)
• HSPA: 2 Mbps (UL), 7.2 Mbps (DL)
• EGPRS: 21.4 Kbps (UL), 85.6 Kbps (DL)

Bands: 1/2/3/4/5/7/8/12/13/18/19/20/26/28/ 66/71

• RF Bands EGPRS: Quad Band
• LTE: 3GPP E-UTRA Release 13 CAT 4
• CPU: ARM Cortex-A7 up to 1.3GHz, NAND/LPDDR2 up to 240Mhz
• Location: GPS, GLONASS, BeiDou Integrated
• 2G Fallback Support
• Compatible with Existing LTE Network
• Optimized for high bandwidth, including audio
• Ideal for devices on the move
• Ideal for applications that require internal location information
• 32292.4mm, LCC Case
• RF Bands EGPRS: Quad Band
• ● LTE: 3GPP E-UTRA Release 13 CAT 4
• ● CPU: ARM Cortex-A7 up to 1.3GHz, NAND/LPDDR2 up to 240Mhz
• ● Location: GPS, GLONASS, BeiDou Integrated
• ● 2G Fallback Support
• ● Compatible with Existing LTE Network
• ● Optimized for high bandwidth, including audio
• ● Ideal for devices on the move
• ● Ideal for applications that require internal location information
• ● 32292.4mm, LCC Case

Cavli C100QM LTE yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

Cavli C42QM LTE: Advantages of Cavli

• Optional Built-in eSIM (Remote Programmable SIM)
• Access to local and global mobile data tariffs via Cavli Hubble
• Direct and very easy mobile subscription with Cavli Hubble, activation, payment and automatic transition to local mobile subscription with eSIM
• Easy firmware installation/update with OTA/Over-the-air

Data and Connection type

• LTE-M1: 100 Kbps (UL), 300 Kbps (DL)
• NB2: 159 Kbps (UL), 127 Kbps (DL)
• NB1: 62 Kbps (UL), 26 Kbps (DL)
• EGPRS: 21.4 Kbps (UL), 85.6 Kbps (DL)

Technical Specifications

Bands: 1/2/3/4/5/7/8/12/13/17/18/20/26/28/ 66/71

• RF Bands EGPRS: Quad Band
• LTE: 3GPP E-UTRA Release 15 CAT M1/NB1/NB2 CPU: ARM Cortex-A7 up to 1.3GHz, NAND/LPDDR2 up to 240Mhz
• Location: GPS, GLONASS, BeiDou Integrated
• 2G Fallback Support
• Excellent performance even in indoor areas
• Compatible with Existing LTE Network
• Optimized for high bandwidth, including audio
• Ideal for devices on the move
• Ideal for applications that require internal location information
• 22.526.52.4 mm, LGA Case

Cavli C42QM LTE yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.

Features

• Bluetooth 5 / Bluetooth Mesh / Thread / ZigBee / 2.4GHz / Ant
• USB Support
• 32-bit ARM Cortex M4F processor with 64MHz speeds
• 1MByte Flash / 256KByte Ram support
• FPU (Floating Point) / DSP 
• (Digital Signal Processing) support
• ARM TrustZone CryptoCell-310 cryptographic security support

Nordic nRcF52840 yazısı ilk önce Component By Özdisan üzerinde ortaya çıktı.